Roof to Top of Wall Connection Metal hurricane straps or clips provide the proper measure of strength and safety for the roof-to-wall connection. The common practice of toenailing the trusses or rafters often is not sufficient to hold a roof in place in high winds. These clips or straps are usually very difficult to see from the attic because of insulation. Areas where the roof framing meets the top of stud walls are normally covered by dry wall on the inside and by wall cladding and soffit board on the outside. To install hurricane straps and clips, remove the roof sheathing around the perimeter of the roof to reveal the top of the wall. You may also need to remove the soffit and exterior cladding to reveal the top 12 to 18 inches of the wall. In addition, if the exterior cladding is brick veneer, you may need to remove small sections of brick as needed. If your roof has trusses, make sure you tie them to the wall by either anchoring to the top plate and then the top plate to the wall stud, or strapping the truss directly to the wall stud. The above information is taken from IBHS's instructive pamphlet, "Is Your Home Protected from Hurricane Disaster? -A Homeowner's Guide to Retrofit." |
Marketplace
Stay ahead of the storm. Find evacuation routes, safety tips and more in the Hurricane Guide .
Don't miss your favorite TV shows! Click to get the latest WFTV Channel 9 programming schedule.
© All Media Guide, LLC. Portions of content provided by All Music Guide®, a trademark of All Media Guide, LLC.